Studer XTH 6000-48 Inverter Swiss Made
On Alps or other remote lodges one knows the problem with the power supply with diesel generators. Again, even if only small loads are connected, the diesel has to run, on the other hand, the power consumption rises again with new equipment and the diesel group takes over this short time to your benefit limit.
A very large diesel generator must then for this very short times to be purchased.
Both problems (underload / overload) are dissolved with the SMART BOOST system from Studer very elegant. If the energy consumption is very low, the diesel can be switched off, the load is powered from the battery via Xtender with 230V. Once larger loads are switched on or the battery is discharged, the diesel is started and operated at medium power with good efficiency. The energy used is not required is stored in the battery.
Now increases the energy demand at a higher value than the power of the diesel generator, the diesel is running on full load AND the Xtender brings full power from the battery, so that for a short time depending on the design eg twice the generator power is available.
Now available, a battery and a stand-alone inverters, can be reloaded easily with photovoltaic or wind energy, so as except seasonal is no longer needed, the generator.
In principle, the system compares a hybrid automobile and provides the same benefits.
rated voltage: 48 V
min / Max input voltage: 38-68 V
continuous power 5000 VA
Peak power for 30 min at 25 ° C approx. 6000 VA
Max power 5 sec at 25 ° C ca. 15000 VA
nominal output voltage 230V pure sine 0 / -10% ( short-circuit protected)
output frequency 50 Hz +/- 0.05%
Permitted cos phi 0.1 - 1
efficiency max. 96%
consumption standby 2.2 W (load detection 2 - 25W adjustable)
Power consumption 22 watts at idle
charge current: 0 - 100A, optimized 5-stage process
Permissible ambient temperature -20 ° C to + 55 ° C
dimensions: 230 x 300 x 500 mm (LxWxH)
Manufacturer warranty: 2 years