Bidirectional 500 watt sine wave inverter 12V to 230V Xtender XTS 900-12

P0715


Studer XTS 900-12 Inverter Swiss Made

More details

CHF 1,580.00

More info

On Alps or other remote lodges one knows the problem with the power supply with diesel generators. Again, even if only small loads are connected, the diesel has to run, on the other hand, the power consumption rises again with new equipment and the diesel group takes over this short time to your benefit limit.
A very large diesel generator must then for this very short times to be purchased.
Both problems (underload / overload) are dissolved with the SMART BOOST system from Studer very elegant. If the energy consumption is very low, the diesel can be switched off, the load is powered from the battery via Xtender with 230V. Once larger loads are switched on or the battery is discharged, the diesel is started and operated at medium power with good efficiency. The energy used is not required is stored in the battery.
Now increases the energy demand at a higher value than the power of the diesel generator, the diesel is running on full load AND the Xtender brings full power from the battery, so that for a short time depending on the design eg twice the generator power is available.
Now available, a battery and a stand-alone inverters, can be reloaded easily with photovoltaic or wind energy, so as except seasonal is no longer needed, the generator.

In principle, the system compares a hybrid automobile and provides the same benefits.

SWISS MADE

Specifications:
rated voltage: 12 V
min / Max input voltage: 9.5 - 17 V
continuous power 500VA (650VA with fan module ECF-01)
Max. power 30 min at 25 ° C approximately 700 VA (900VA with fan module ECF-01)
Max. capacity 5 sec at 25 ° C 2300 VA

inverter:
nominal output voltage pure sine wave 230V +/- 2% (short-circuit protection)
output frequency 50 Hz +/- 0.05%
Permitted cos phi 0.1 - 1
efficiency max , 93%
consumption standby 1.4 W (load detection 2 - 25W adjustable)
Power consumption 7 watts at idle

Battery charger:
charge current: 0 - 35A, optimized 5-stage process

General data:
Permissible ambient temperature -20 ° C to + 55 ° C
dimensions: 110 x 210 x 310 mm (LxWxH)
weight: 8.2 kg
Manufacturer warranty: 2 years

Download

12 other products in the same category: